VOOPOO VINCI AIR KIT/ User Manual

As you know, the VOOPOO VINCI series has been the focus since its launch. After VINCI and VINCI X, here comes another hit device- VINCI Air! This time we will share the tips for using it.

Construction of VINCI AIR

Parameter

Material	PCTG + Zinc Alloy
Size	100.9 x 27 x 18mm
Pod Capacity	4ml
Battery Capacity	900mAh
Output Power	5-30W
Output Voltage	3.2~4.2V
Standard Coils	0.6Ω（PnP-VM4); 1.0Ω（PnP-R2）
Compatible Coils	PnP-VM3 / PnP-R1 / PnP-RBA

Operations Steps

Step l. Install coil

Take out the coil, and Insert the coil from the bottom of the pod.

Step 2. Fill e-liquid

Pull out the silica gel plug according to the instructions, then refill e-liquid from oil-filling slots.It is recommended to keep two thirds full.

Step 3. Install the atomizer

Insert the atomizer with e-liquid into the mod.

Step4. Start to use the device

After keeping it stand for about five minutes, you are free to use the device. You can rotate the pod 180 degreeS to adjust the airflow in order to enjoy optimal vaping experience.

Interface introduction

Function description

1.0n/off: Short press on fire button five times.

2.Puff clear: Press the fire button and"-" button at the same time.

3.Lock/unlock: Press the fire button and "+" button at the same time.

(The product can not be fired when locked or adjust power.)

4.Charging: Support charging with 5V/1A. It is recommended to use the USB cable provided by VOOPOO to charge the device.

(Do not use during device charging.)

5.Status notification

Security Protection

-Low battery protection

-Atomizer short-circuit protection

-Max Power Protection

-Overtime protection

-Over-temperature protection

-Output over-current protection

-Overcharge protection

This is the end of the article. Welcome to leave your thoughts.