As you know, the VOOPOO VINCI series has been the focus since its launch. After VINCI and VINCI X, here comes another hit device- VINCI Air! This time we will share the tips for using it.
Construction of VINCI AIR
Parameter
| Material | PCTG + Zinc Alloy |
| Size | 100.9 x 27 x 18mm |
| Pod Capacity | 4ml |
| Battery Capacity | 900mAh |
| Output Power | 5-30W |
| Output Voltage | 3.2~4.2V |
| Standard Coils | 0.6Ω（PnP-VM4); 1.0Ω（PnP-R2） |
| Compatible Coils | PnP-VM3 / PnP-R1 / PnP-RBA |
Operations Steps
Step l. Install coil
Take out the coil, and Insert the coil from the bottom of the pod.
Step 2. Fill e-liquid
Pull out the silica gel plug according to the instructions, then refill e-liquid from oil-filling slots.It is recommended to keep two thirds full.
Step 3. Install the atomizer
Insert the atomizer with e-liquid into the mod.
Step4. Start to use the device
After keeping it stand for about five minutes, you are free to use the device. You can rotate the pod 180 degreeS to adjust the airflow in order to enjoy optimal vaping experience.
Interface introduction
Function description
1.0n/off: Short press on fire button five times.
2.Puff clear: Press the fire button and"-" button at the same time.
3.Lock/unlock: Press the fire button and "+" button at the same time.
(The product can not be fired when locked or adjust power.)
4.Charging: Support charging with 5V/1A. It is recommended to use the USB cable provided by VOOPOO to charge the device.
(Do not use during device charging.)
5.Status notification
Security Protection
-Low battery protection
-Atomizer short-circuit protection
-Max Power Protection
-Overtime protection
-Over-temperature protection
-Output over-current protection
-Overcharge protection
This is the end of the article. Welcome to leave your thoughts.
